Mamac Pressure Transducer

(DN 264.2)

Tech. sheet

(IS PR264)

Features

100% solid-state fused silicon pressure sensor

Up to 300% overpressure without zero shift

Rugged, leakproof 316L stainless steel monolithic pressure cavity with no welds, O-rings, seams, or bonds

Over 500% burst pressure

Up to three field selectable ranges in a single transducer

Wide 12 to 40 VDC/12 to 35 VAC unregulated supply voltage

Two temperature compensated output versions: 4 to 20 mA 2-wire or field selectable 0 to 5 VDC/0 to 10 VDC

NIST traceable calibration

Rugged NEMA-4/IP-65 enclosure with external mounting bracket

Short circuit and reverse polarity protected

Conforms to EMC standards EN50082-1/EN55014/EN60730-1

WARNING: Some of the products we sell can expose you to chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. Contact your sales rep or go to www.P65Warnings.ca.gov for more information.

All registered trademarks are fully acknowledged by: M&M Control Service, Inc.

M&M Control Service, Inc. does not represent or claim any affiliation, association, connection or approvals with or from any manufacturer unless stated. We fully acknowledge all trademarks and/or names which are pictured and/or listed throughout the M&M Control Service, Inc. Website.

(Powers^TM, also known as, POWERS REGULATOR, MCC POWERS, POWERS-FIAT, POWERS PROCESS CONTROLS, CRANE POWERS and POWERS, a Watts Industries Company. The POWERS trademark is owned by Powers, A Division of Watts Water Technologies, Inc. M&M Control Service, Inc. Is a Stocking Distributor for Powers^TM)

(All names unintentionally excluded from this list will be included in the next revision upon our notification.)

*This list may vary, as names not appearing on this list are entitled to the acknowledgment of their Trademarks by M&M Control Service, Inc.